HighPercentile
Posted
10 months 3 weeks ago
Hi all, long story short—this is about my original Triton Two’s purchased in 2015 which are running off of a Marantz SR-7010—there are many other speakers in the system but they don’t apply here. The Right Triton Two’s amp was replaced about 2 years ago and an amp was also replaced in 2016 although I don’t recall which of the Two’s that issue was for. Also, the Marantz is set to LFE ON, speakers Large, crossover is about 120Hz in the amp settings.
Anyway, after swapping my center SuperCenter X this past weekend for a SuperSat 60c, I realized that I had been getting very little bass from the R Two. Swapped wires/terminals/etc. and what I discovered is that the R’s sub will turn on with ONLY the RCA wire’s central tip inserted; any more and it goes out again if the RCA outer sleeve portion touches the jack on the speaker. LED’s are all acting normally and lit up throughout on both speakers.
I’ll state that again; my Right Two’s sub only works if just the central post of its LFE RCA cable is inserted; if the outer sleeve touches, the bass goes out again. It’s barely hanging on by friction and heavy bass may well dislodge it. I’ve run all types of frequency sweeps and the phasing seems to be correct.
And then weirdness #2: during all this testing and swapping wires, the LEFT Two seemed to be chugging along happily. However if I switch the amp to No Sub/No LFE/Large full-range, that speaker loses it’s bass if I unplug the LFE RCA wire from it and that shouldn’t happen since I’m running the speaker at full-range. So now I’m stuck not knowing if it’s an amp issue, dual speaker issues, or a mix of both.
Any ideas?? This really sucks!
Please Log in or Create an account to join the conversation.