|
arrow_downward
|
|
 |
hello
Normally to clean the grill, I would take it off the speaker and use a vacuum cleaner to get off the biggest dust.
But over time, the fine white...
|
|
|
My flat panel TV is mounted at eye height, with the SuperCinema 3D Array below it. Because the SuperCinema is wall mounted and in quite a low...
|
 |
I made a post before, but did not see it afterwards. Trying again. Hopefully not a double post.
I recently set up a SuperCinema, SuperSat3 and...
|
|
|
I have a 65" plasma that I will be building a cabinet for. I am planning on putting the bottom of the display at 24" from the floor or so. I am trying...
|
|
|
Hi All,
Can someone please share their experience with mounting the soundbar on the wall. No wall mounting hardware was included with the soundbar....
|
|
|
Sanus makes a soundbar mount (VMA202) for the swivel TV mount I have. To me, it seems like it will work and sound fine with the SuperCinema and look...
|
|
|
I just bought the Supercinema 3D Array, Forcefield3, and Invisa650's, to be installed next week. Very excited to say the least.
My question: My...
|
|
|
I've been trying to figure out placement for SuperSat 50's and it has been a challenge. I can only separate the front speakers 5' apart and read...
|
|
|
Hi There,
I auditioned the SS3 speakers and almost bought them.
Really liked them for the price.
But then I found out about the SuperCinema sound...
|
|
|
From Northern Audio & Home Theatre, a dealer in Pittsburgh, comes a suggestion;
The size of the 3D array (50") removes it from consideration when...
|
|
|
MTM designed center channels have proven problematic with considerable interference between drivers and often poor and irregular dispersion from the...
|
|
|
I'm planning to replace my current Def Tech surround system (BP7002s, CLR, rear speakers, etc.) with a much more living room friendly soundbar and sub...
|
|
|
Would I get a better result if I paired up the 3d array as a center channel with the triton 2s or is that a bad choice and I should go with the...
|
|
arrow_upward
|
|
