GoldenEar | A Passion for Sonic Perfection

Triton 1 no bass

Start
Prev
1
2
Next
End

1
2

Offline
Elite Member
Lovin' GET T1s

Posts: 302
Thank you received: 633
Karma: 1

More Less

Pbgalvin Posted 4 years 7 months ago

#28256

Are you sure you don't have your processor set to small rear speakers or some such?

2 channel -> GeT Ones.R, Rogue RP-7 pre, Kinki Studio B7 Monoblock amps fed by Oppo 105D, SonicTransport, OpticalRendu w/ 200,000 tracks, Rega RP8 w/ Garrott OPTIM S3 FGS Ruby + Sutherland 20/20 phono pre, PS Audio Powerplant 20
HT -> Marantz 7703, Butler Audio T5150 amp, GeT Ref mains

Please Log in or Create an account to join the conversation.

Offline
Junior Member

Posts: 23
Thank you received: 16

More Less

grg1120 Posted 4 years 7 months ago

#28257

Yes I tried it on a two channel system.

Please Log in or Create an account to join the conversation.

Offline
Moderator

Posts: 3350
Thank you received: 3419
Karma: 19

More Less

Moderator Posted 4 years 7 months ago

#28293

Sorry for the delay.

If you haven't tried it yet, let's do a hard reboot of the speaker. Set a timer on your phone for 15 minutes or longer. Disconnect power and start the timer. This will allow the speaker enough time to completely drain. Once the timer is complete (or longer) reconnect power. The light on the back should flash for 20-30 seconds +/- as the firmware reloads. Most of the time this will do the trick.

Please Log in or Create an account to join the conversation.

Offline
Moderator

Posts: 3350
Thank you received: 3419
Karma: 19

More Less

Moderator Posted 4 years 7 months ago

#28382

Try a hard reboot of the amplifier. Set a timer on your phone for 15 minutes (can be longer) and disconnect the power. Start timer. This will allow the amplifier time to fully drain. When the timer is finished (again, can be longer) reconnect power. The light on the back will flash for 20-30 seconds as the firmware reloads. Most times this does the trick.

Please Log in or Create an account to join the conversation.